MPLS VPN VRF Based On Source IP Address

Introduction

This feature allows to select the VRF based on source IP address. It does not require PBR on the interface.

MPLS VPN VRF Based On Source IP Address

  • This feature is available on only very select hardware:
    • 7500
    • 7304-NSE-150
    • 7304-NSE-100
    • 7304-NPE-G100
    • 7201
    • 7200-NPE-G2
    • 12000-PRP
    • 12000-GRP
    • 12000-PRE4
    • 12000-PRE3
    • 12000-PRE2

Additional Resources

MPLS VPN - VRF Selection based on Source IP Address - Cisco

Comments

rating: 0+x
Unless otherwise stated, the content of this page is licensed under Creative Commons Attribution-ShareAlike 3.0 License